Online Service
Contact: Mr. Li 18681482740
Email: lilinhan1314@126.com
Website: www.dg-hzh.com
Shenzhen Licao Precision Mold knows that waste disposal is a very dangerous job. It is best to use automated processing. Of course, some waste must be treated manually. What issues should we pay attention to when dealing with metal stamping waste? There may be many friends. Not sure, let's take a look at the editor below.
Firstly, we know that there are two types of metal stamping waste packaging, one is automatic processing, and the other is non automatic processing.
Scrap processing of hardware stamping parts in Shenzhen
Safety measures for automatic processing of scrap metal stamping parts:
1. Shenzhen Ligao Mold can set up cutting knives on hardware stamping molds to cut waste materials, and then press them onto the packaging machine on the conveyor belt. Additionally, pay attention to cutting off the printing press once every time it is pressed.
2. The metal stamping waste is wound by a paper winding machine. In fact, the appearance of a reel is similar to that of a reel. After winding the scrap of metal stamping parts through a tape reel, it can be used as a material for other components. As the receiving reel motor is independently driven, it can also be driven by a press or feed mechanism.
3. When using ordinary paper processing, the waste of hardware stamping parts is transported by conveyor belts, cut by waste shredders, and then pressed into squares.
Non automated safety measures for scrap metal stamping parts in Shenzhen:
1. To prevent accidents, we should add a protective cover and prevent waste from flowing or flying around the operator during operation.
2. It is best not to grind corners or burrs on waste to avoid injury to people. When cutting, the size of waste should be appropriately reduced to avoid injury to operators near algae.
3. If the waste cannot fall by itself, once it is suspended on the cutting edge, it should be forcefully thrown down using throwing devices such as.
Shenzhen Hardware Stamping Scrap
4. The chute used for cleaning waste must pass through the end of the gasket and align with the opening of the waste pit. When installing the chute, please pay attention to whether the screws of the metal stamping mold are tightened.
5. When waste passes through pipelines, it should be noted that if the width and height of the waste are not enough, it is easy to block, and it is also necessary to avoid transmitting two or more types of waste on one pipeline.
6. When punching waste, the waste should be automatically layered and broken. If the waste from two places is collected together, at least 100 pieces of waste should be stored in the upper or lower mold base, and there must be sufficient space for stacking. The above briefly introduces the issues that should be paid attention to when handling metal stamping waste. The editor also reminds friends engaged in waste packaging to pay attention to safety and avoid accidents.